POJJO VVS-10012 Manuel d'instructions télécharger pdf (Page 11)

Unframed Cabinet

When a cabinet is unframed with a false panel, there is usually a supporting panel

behind it. In order for the false panel to turn into a door, you must create a minimum

5” opening in height with a 3/4” deep rail to mount the hinge and door. To achieve

that design, you may have to trim the support panel to provide an upper and lower

support beam as described in the Unframed Cabinet diagram. Round (router) the top

and bottom edges of the opening - specically the top outside edge and the bottom

inside edge. This reduces the chances of hitting your hand as it goes in and out of the

opening to manage tools.

General Considerations:

* The VVS does not work with rectangle sinks

* The VVS does not work with bathroom cabinets that do not have a false panel

* The opening to false panel should be at least 5” in height to allow blow dryers

which are usually between 3.5”-4” in diameter to clear.

* Insert the blow dryer horizontally, through the false panel opening, into the 3“ hole,

then rotate vertically.

* A standard false panel on a 24“ cabinet with a minimum height of 5” will support 2

wrapped cords spaciously, and 3 snuggly.

* A standard false panel on a 30” cabinet with a minimum height of 5” will support 4

wrapped cords.

1 2 ... 6 7 8 9 10 11 12

Pas de commentaire

POJJO VVS-10012 Manuel d'instructions Page 11